error angle
英 [ˈerə(r) ˈæŋɡl]
美 [ˈerər ˈæŋɡl]
网络 误差角
双语例句
- Study on Leading Error and Angle Acquisition Problems of Composite Guidance Antiaircraft Missile
防空导弹复合导引引导误差与角度截获问题研究 - A error limitation of angle and chordal highness method is used to filtrate clouding point.
对大量数据的精减，利用角度和弦高的最大允许偏差法进行点云精减。 - The math model of servo system was established with voltage equation in rotor coordinate system of motor, angle error and angle speed error was described with the expected value of dynamic angle and practical angle value.
由伺服电机转子坐标系电压方程建立的伺服系统数学模型，以电机动态角度期望值和实际角度值描述角误差和角速误差。 - The preliminary results are as follows: 1. The horizontal turning angular velocity dF1 ( t0) of male chasing fly linearly depends on the horizontal error angle T1 ( t0-t) of female leading fly.
其结果如下：1.追逐雄蝇水平方向偏转的角速度dF1线性地依赖于目标蝇水平方位误差角T1的大小。 - The results demonstrate three-position alignment to raise the degree of observability of azimuth error angle and vertical axis gyro error., accelerates the convergence of error. Thus increase the system alignment and calibration accuracy.
仿真结果表明三位置对准提高了方位误差角及垂直陀螺误差的可观度，从而加速了它们的收敛速度，提高了系统的对准、标定精度。 - Test on Decreasing PIGA's Input Error Angle by Three-axis Turntable
用三轴转台减小陀螺加速度表输入失调角的试验研究 - Method of direction-finding and positioning based on satellites passive location system by the phase interferometer is presented. And precision analysis of location error by angle measurement is proposed.
研究了相位干涉仪测向体制下星载无源定位系统测向定位的原理和定位的解析算法，并分析测向误差对定位精度的影响，给出了一种比较直观和简便的定位误差分析方法。 - Research of Fix Error Angle for PIGA's Error Models Effect
安装误差角对陀螺加速度表的误差模型的影响 - It has been proved by the experimental results that the system achieved the design requirements, which angular resolution of display is 0.1 "and measuring error of angle is ± 0.3".
实验结果表明系统显示角度分辨率为0.1“，角度测量误差为±0.3”，达到设计要求。 - Based on the error model of three-axis gyroscope, a close-looped multi-iteration calibration method is presented to compensate the scale factor and the error angle.
根据三轴陀螺组合的误差模型，提出了一种闭环多次迭代标定方法解决了陀螺标度因数和安装偏角的精确标定问题，并编制了相应的标定解算软件。 - According to the accuracy index of specifications, analyses the reason that the mean square error of angle exceeds the limitary error;
根据《规范》精度指标，分析了测角中误差超限的原因； - This paper also analyses how to realize distribution of angle measuring error when we are given to the certain error of angle measurement.
论文还分析了在给定测角误差情况下，如何实现测角误差分配。 - A new method wiring diagram of+ 30 ° compensation is proposed, by which the error angle of circuit in work survey is compensated.
提出了测功电路误差角补偿的新方法&+30°接线补偿法。 - It simulates the actual process of transfer alignment in air and evaluates the error angle between a missile inertial navigation system and a reference system. Based on the semi-physical simulation plan, a testing system was constructed.
该半物理仿真系统模拟空中传递对准的真实过程，评估出导弹惯导系统相对于基准系统的失准角，搭建了给予该方案的半物理仿真试验系统。 - In order to improve the velocity of alignment, a fast estimation method of the azimuth error angle is proposed for the initial alignment of INS. The simulation results illustrate the efficiency of the method.
为提高对准速度，文中给出了方位误差角的一种快速估计方法，结果表明该方法是可行的。 - A curve of sine approximate error in angle measure is devised, a mathematical model of the measurement error is presented.
作出了角度测量中正弦近似误差特性曲线，并提出了该测量误差的数学模型； - Four main repeatability errors, i. e grating constant error, zero point scaling error, measuring error for turn angle and measuring error for angle between incident light and diffraction light are analyzed according to the measuring principle using plane glare grating as spectral elements of far-infrared spectrometer.
采用平面闪耀光栅作为光谱元件的远红外光谱测量原理，分析了四种主要的重复性误差：光栅常数制造误差、零点标定误差、转角测量误差、入射光束与衍射光束的夹角测量误差。 - Calibrate the zero position, the scale factor and the error angle of accelerometer by the 9-position method.
采用了九位置法对加速度计的零位、标度因数和安装偏角进行标定，并编制了相应的标定解算软件。 - Fourthly, it describes the radar signal processing model. This part chiefly researchs the buffer, the pulse compress and the GO-CFAR, then it discusses how to solve the error angle.
接着阐述了雷达信号处理模型，研究了缓存器结构，脉冲压缩理论，单元平均选大恒虚警处理（CFAR）模型，以及解角误差理论； - The Modification of Fuzzy Control Volume Using Gradient Error Angle
用梯度误差角修正模糊控制量 - Linear error models used are designed commonly in the assumption of a small attitude error angle, and because of neglecting the high order items, when there is a big navigation error, the linear error models can not accurately describe system nonlinear characteristics.
常用的线性误差模型都是在假设姿态误差角是小量的情况下得到的，由于忽略了高阶项，所以当存在较大的导航误差时，线性化误差方程就不能精确地描述系统的非线性特性。 - At the same time there is a brief analysis for angle testing theory and locating error during angle adjusting.
同时，对自调整角度机的定位误差和角度测量原理进行了简要说明和分析。 - An experimental system is built based on rotary Dove prism. By simulating the displacement error and angle error between the different axes, the curves of track shift of exit rays and loss variation were obtained. 4.
构建了旋转的道威棱镜实验系统，对棱镜轴、机械旋转轴和入射光轴之间的位移误差和角度误差进行了模拟，得到出射光线的轨迹变化曲线和损耗变化曲线。 - Main researches are as the follows. 1. The error characteristic of rate biased RLG ( core parts of north finder), is theoretically studied. The primary errors of rate biased RLG are bias instability error, quantification error and angle random work error.
论文的主要工作包括：1.理论分析了速率偏频激光陀螺（寻北仪核心器件）的误差特性。速率偏频激光陀螺的误差主要是角度随机游走误差、零偏不稳定性误差和量化误差。 - This paper simulated translation method and analyzed the influence of zero-adjusting error and angle error. Finally, use translation method for guide measurement.
文中对平移法进行了仿真，分析了有无调零误差及偏角误差的影响，最后使用该方法进行导轨的直线度误差测量。 - Taking the small misalignment angle and small installation error angle as research object, and inferred the velocity matching, the attitude matching and the velocity plus attitude transfer alignment matching method error model, and established the kalman filter model.
在主、子惯导系统之间的失准角为小角度的条件下，分别推导了速度匹配、姿态匹配以及速度加姿态匹配三种传递对准常用匹配方式的微分方程并建立了卡尔曼滤波模型。 - Analyses the error sources of laser measurement positioning system, including distance error, Angle error, the agency error and the tracking error, and points out the distance error as the main error sources.
分析了激光测量定位系统的误差来源，其中包括距离误差、角度误差，机构误差以及跟踪误差，指出了其中距离误差为主要误差来源。 - The results show that the north finding precision, in short turn north finding, is primary influenced by quantification error and angle random work error. The mechanical error of north finder is a fixed error when there is no perturbation. 3.
结果表明，影响寻北仪短时寻北精度的误差主要有量化误差和角度随机游走误差，而寻北仪的机械误差在没有扰动下是固定误差。